This Recirculation valve (quiet in operation) is for the BMW 235 3.0 Petrol Turbo engine, as found in the F22 chassis model that has a single electronically controlled bypass valve. This product is recommended for both unmodified vehicles and any vehicle where the boost pressure has been increased by an ECU software upgrade, as a replacement to the OEM bypass valve. Unfortunately the standard valve fails when the plastic deteriorates with age normally resulting in a check engine light. Unfortunately the valve may still partially function, so you may not be aware that you are losing power due to this. This particular failure can also result in the valve falling apart upon removal from the turbo, and in extreme cases, bits of plastic entering the turbo, resulting in serious damage.
Our alternative is a fully engineered solution offering significantly improved reliability. Our valve is piston based, with no diaphragm to fail, and with a body of all aluminium construction. It’s also fully serviceable and the spring strength can be changed to suit increased boost levels. Most importantly it still also retains the desirable OEM ECU control over valve actuation, with the inclusion of an electrical harness that plugs straight into the BMW wiring. It’s literally plug and play.
THIS IS ONLY AVAILABLE IN BLACK
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please call our customer service team on +44(0)1452 380999 or email firstname.lastname@example.org.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.