Keep your Pipercross air filter in peak condition with a filter service kit. Each kit includes 75ml of Dirt Retention Additive and 75ml Cleaner, all you need to service your filter.
The superior foam construction of Pipercross filters allows them to hold more dirt and remain efficient for two to three times longer than conventional paper or cotton gauze filters. When the time does come to clean your filter, this cleaning fluid helps remove debris and contaminants from the multi-layer foam media, restoring proper airflow.
STEP ONE: Remove excess dirt by gently brushing the filter.
STEP TWO: Apply cleaning additive liberally. Massage in with soft brush. Allow to soak for around 5 minutes.
STEP THREE: Flush the filter out with warm water from the clean side of the foam to the dirty side.
STEP FOUR: Allow the filter to dry naturally (do not apply any heat to the filter!!)
STEP FIVE: Lightly apply dirt retention additive to both sides of the filter.
STEP SIX: Wipe off the excess additive.
Steps two, three and four may need to be repeated until the filter is clean.
Many Pipercross filters utilize an oil filter element and will require Pipercross' Dirt Retention Oil to be applied after cleaning, but not all.
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please call our customer service team on +44(0)1452 380999 or email firstname.lastname@example.org.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.