This plastic sheet stencil can be used to spray or paint on the Forge logo onto an intercooler and more!
For the best result:
- Use masking tape to secure the stencil in a fixed position, double check the location and cover any other components you do not wish to get paint on (fenders, bumpers, reservoirs etc).
- Spray the paint about 300mm away from the stencil. For the best finish, apply two or three thin layers - This will give an even paint coverage and avoid runs.
- Wait for the paint to dry between layers.
- Wait for paint to dry completely and remove stencil.
*Forge Motorsport accept no responsibility for damage caused by improper use and/or installation of our products*
320mm x 125mm
Plastic Sheet Dimensions:
450mm x 320mm
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
It worked great for me. Used it to really bring out the forge logo on my intercooler and it came out really nice. One thing would be they should probably make the paper a little thicker or a thin plastic so it stays down during spraying.
Honestly should be about %20 smaller because it didn’t really fit the intercooler. Also should be thicker or made from plastic. The card board lifted even when I third to hold it down. Made for a messy paint job and a lot of overspray.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please call our customer service team on +44(0)1452 380999 or email email@example.com.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.
Blow Off Valve for Ford Focus RS MK3 & Vauxhall Adam, Astra, Corsa, and more
Manufacturer: Forge Motorsport