As an alternative recirculation valve on the Audi TT RS 5 cylinder engine, this kit is a fully engineered solution offering both significantly improved reliability as well as valve related boost response. Our valve and installation kit replaces the original unit with a pressure/vacuum operated piston valve that still also retains the desirable OEM ECU control over valve actuation.
This product has been thoroughly designed and tested with the expressed intent of offering improved valve response and maintaining ECU control while resulting in absolutely NO fault codes, NO check engine lights, and no adverse effects of any kind. All of the necessary components and detailed instructions are included and everything is designed to make installation as simple as possible. This kit is supplied with an additional uprated spring that may be required if the vehicle has had a significant boost increase after an ECU performance upgrade.
For those planning to tune their vehicles in excess of 450hp we recommend the use of our FMARSDV.
In The Box:
1 x FMDVAURS Valve
1 x Wiring Harness
1 x Solenoid, Bracket, and Screws
1 x Uprated Red Spring
10 x Cable Ties
1 x 2000mm of 4mm Vacuum Tube
1 x Vacuum Tap and Gasket
2 x M6 x 35 Socket Cap Screws
1 x Instructions
1 x Forge Keyring and Sticker
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
Replacement Piston Valve and Kit for 2009 Onwards Audi 5 Cylinder Engines
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please call our customer service team on +44(0)1452 380999 or email email@example.com.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.
356mm Front Brake Kit for the Hyundai I30N/ Veloster N
Manufacturer: Forge Motorsport