A Cold Air Induction kit utilising a Dual cone low resistance air filter coupled with carbon fibre and silicone to achieve maximum flow rates and high density intake charge.
(Air mass sensors shown in the above image are not supplied with this kit)
This kit is suitable for Golf MK4 platform vehicles with the 1.8T petrol engines including Seat Leon and Cupra (but not Cupra R), Skoda Octavia, Audi A3.
This kit is suitable for off road track use only
Please watch our video on how to fit an air filter without damaging it.
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
I purchased this item for my Golf MK4 with the 2.0L engine. Even though the description says it only fits the 1.8t engine, I figured it would fit my 2.0L because the airbox is in the same location, and I was correct. The instructions included were a great help. Fitting the silicone sections to the piping and putting the filter on was fairly difficult because they are so tight, but I suppose that's a good thing so it won't come apart. This item requires no modification, only removal of the factory airbox and tubing. I actually noticed better throttle response in 1st, 2nd, and 3rd gear, but I can't say the same for the 1.8t, as it's on my 2.0L. Shipping was very quick, under 48 hours, included tracking number and everything. Overall, very pleased with this item, would definitely recommend.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please call our customer service team on +44(0)1452 380999 or email firstname.lastname@example.org.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.