This kit allows you to relocate the diverter valve from the hot side of the turbo to the cold side of the intercooler on the VW Golf, SEAT Leon (not Ibiza), Skoda Octavia and Audi A3, TT 1.8T engines of 150 - 180 HP. For the 210/225 versions of this engine please see FMDV225RLK By relocating the valve in this way there are two benefits.
Firstly, due to operating in lower temperatures the longevity of the valve is increased. Secondly, after relocation, the air that is recirculated back into the intake tract to the turbo will be cooler. Cooler air has a greater density. The greater the density of the charge mix in the cylinder the more power generated on combustion.
Please be aware that these hoses were patterned from right hand drive vehicles. Whilst we believe these to be correct for left hand drive vehicles we suggest that you visually check their suitability, as replacement items, with those fitted to your own vehicle, before attempting installation.
***Valave not included in kit. Much be purchased separately***
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please call our customer service team on +44(0)1452 380999 or email firstname.lastname@example.org.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.